Playspace mover oculus rift s4/10/2024 No red leds in the centre/not showing on steam even with tracker paired and visible (Thanks to Eray-Kun for finding and fixing this issue). Jitter/Avatar jumping up and down repeatedly.I already have two controllers connected.Automated config modification 2 (manual).More fixes will be posted as they are come across, please be patient.Playspace mover is snapping me back to the center and SteamVR says my room setup is invalid even after pasting my chaperone profile.I use the oculus controller as my hip and it's below the floor!.My head is NOT in the ground, but my room setup is still wrong!.My trackers are way below my body/the ground!.Nothing is showing up in SteamVR anymore!!.Plug in ONE dongle ( Do not plug the dongles into a USB hub for pairing).Then press and hold the Power button for 10 seconds. If the re-pairing process does not work, connect the tracker to your computer using the supplied USBcable, and Fix this by turning off all currently paired trackers, and then one by one (plug in first dongle, pair tracker, plug in second etc.) pairing them again through the steps provided here. This happens if you have two trackers paired to one dongle. Once you've paired all 3 successfully, you may plug the cradles+dongles back into the hub. Plug the dongle and cradle directly into a USB port instead of a hub. This confuses steamVR in the pairing process and may cause a myriad of issues. Make sure when initially pairing, you are not using any USB hubs. The basestations will NOT show up on steamVR until a tracker is paired, turned on, and tracking in your play area Once the light at the top of the basestations turns green you should be ready to continue with the steps.If it still is not turning on, restart SteamVR to ensure the channel changes applied. Short click the button a few times to make sure, and then confirm on SteamVR the channel has changed by hovering over the basestation icon. If one of your basestations is greyed out or will not appear alongside the other basestation, look for the pinhole on the back of the basestation, and press into it with a paperclip or pen tip, gently pressing until you feel the button click. You can check what channel a basestation is on by hovering over it in SteamVR. 2.0 BASESTATIONS (Rounded front) - The two basestations need to be on separate channels.Do this by pressing the button on the back to cycle through the channels. 1.0 BASESTATIONS (Square shaped) - Change the channel (letter on the front) on one basestation to b and the other to c.Plug your basestations into the wall ( NOTE: Basestations do NOT need to be plugged into your PC, only the wall).Position your basestations in opposing corners of your room, placed above your head tilted down, making sure they can still see eachother (ceiling fan etc may cause problems without a sync cable).Preface: The basestations do not need to connect to your computer in any way (usb/bluetooth) for normal functionality, they simply need to be plugged into the wall and configured as below
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |